How To Repair Hole In Wood Paneling

How to repair or replace wall paneling that has been scratched, dented, dinged, or gouged

Like other wall surface materials, board paneling tin can become damaged by everyday wear and tear in a house. Boards can become gouged, scratched, dented, and dinged. Minor scratches and dings can be subconscious or covered up, but you may want to replace panels that are more than seriously damaged with new panels that match the existing paneling.

Real wood paneling is normally private boards jointed together, but a lot of "woods" paneling is actually sparse photograph-laminated sheets designed to look like solid wood. This is an important stardom, considering real boards can exist repaired using conventional woodworking methods, while simulated wood requires more than cosmetic handling.

Repairing Scratches

A slight scratch in a board, for example, merely reveals more of the same woods below, while a deep scratch in paneling tin can expose a paper bankroll or plywood cadre. Paneling sheets also take a clear surface pic that is hard to friction match with whatever type of protective terminate.

Though it is difficult to conceal repairs to veneer or simulated materials, minor scratches and gouges in both sheet and solid-forest paneling can be concealed with a putty stick of matching color. When using a putty stick, make full the scratch so wipe away whatsoever putty on the surface of the paneling with a clean cloth.

For astringent scratches on quality paneling, consult a piece of furniture repair expert who may be able to muffle scratches with furniture polish or an "almond stick"—a compressed cloth stick impregnated with almond oil.

Repairing Gouges

Deep gouges in solid forest paneling can sometimes be repaired if replacing the panel is not a convenient option.

1 Using fine sandpaper, lightly sand in line with the wood grain to remove the finish from around the gouge.

sand wall paneling — Sand in the management of the wood grain.

2 Adjacent, run a hot iron over a damp cloth placed over the damaged area to raise the wood fibers to the level of the surrounding forest.

raise wood grain with iron — Employ an iron and damp textile to raise the wood fibers.

iii Using a putty knife, fill the gouge with putty that matches the paneling. Permit it dry and then lightly sand the surface area shine, working in line with the forest grain.

4 Finish to friction match the surrounding area.

A deep gouge in woodwork can also be repaired by gluing in a new piece of the same blazon of wood. If you glue in a new department of wood, clean abroad any dried glue around the edges of the repair and sand the unabridged section around it before you restain.

Discover Pre-Screened Local Drywall Repair Help